NEWARE Glossary-learning center for battery tester

HOME Glossary

Glossary

Hardware Module

Product Features

Product Parameters

Min Vi

The present step will be cut off when the minimum voltage of the auxiliary channel is less than or equal to the set value.
Max Ti

The present step will be cut off when the maximum temperature of the auxiliary channel is greater than or equal to the set value.
Min Ti

The step will be cut off when the minimum temperature of the present step auxiliary channel is less than or equal to the set value.
Capacity

It represents the electricity of a battery: the amount of charge stored inside the battery when it is charged under the current of 1A for 1h.
Cycle layer

Summary data of cycle, including cycle number, charge capacity, discharge capacity, efficiency, etc.
Lot

A device for holding trays.
Power Factor

Power factor refers to the ratio of active power to apparent power of an AC circuit, and its magnitude is related to the load nature of the circuit.
Metal Oxide Semiconductor Field Effect Transistor（MOSFET）

MOSFE is a semiconductor device and a power control module.
Three-phase five line

Three phase five wire is the connection mode of the input power supply, specifically refers to three phase wire plus a ground wire and a zero wire.
Surge protection.

Surge is the instantaneous peak value beyond the stable value, including surge voltage and surge current. Surge protection is the function of surge protector, which can be switched on and off shunt for a very short time to protect equipment.
Anti-island protection

Prevent islanding effect of power grid. Isolated island will damage the power supply quality of public grid, and there are some security risks.
Under Voltage Protection

When the line voltage is reduced to the critical voltage, the action to protect the appliance is called undervoltage protection, mainly to prevent the equipment from receiving damage due to overload.
Open-phase protection

When a phase of the three-phase power supply is disconnected, the original three-phase equipment will reduce the output power so that it can not work normally or cause accidents, so it is necessary to add a phase protection device to the equipment, in order to avoid damage to the instrument.
Current Accuracy

Percentage error between actual output current and design output current.
Sampling Time

The rate at which the system reads and samples the test data.
Current response time

Time when the device is powered on and the value displayed on the device is displayed.
SMBus communication

Low speed communication for mobile PC and desktop PC systems.
Cycle life

The cycle number before the battery capacity is reduced to a certain value under specific charge/discharge conditions
Plateau voltage

In constant current charge/discharge process, there exists astage where the voltage changes slowly/has a steady process, the corresponding voltage value is called voltage plateau.
Discharge time

The consumed time for a Battery to discharge to the termination voltage.
Capacitance value

The amount of the electric charge stored in a capacitor at a specific electric potential.
Priority mapping

The unassigned auxiliary channels are assigned to the selected main channel in priority.
Reset mapping

Rearrange the channels and display them on the software interface.
Super mapping

The channels of multiple control units are mapped to the same interface.

NEWARE and Cookies

We use Cookie to personalize and improve your experience with our website. By continuing to browse the site you are agreeing to our use of cookies.